Commercial roofing in Dallas

Flat and low-slope roofs for Dallas businesses, built to code

Commercial Roofing in Dallas Built for Texas Weather

A commercial roof is a different job from a house roof: larger areas, flat and low-slope membrane systems, rooftop equipment, drains and parapets — and a business underneath that has to keep operating. We install, repair and replace commercial roofing in Dallas — TPO, EPDM, modified bitumen and metal — with the work sequenced around the building's use.

Open 24 hours, every dayItemised written quotePhotos at every stage
Call firstTell us about the building — size, system, leaks, equipment — and what the business below needs
Safety before speedWe walk the roof and check drains, seams and penetrations before any work is agreed
Diagnose the causeWe trace the leak to its source, not just the ceiling stain
Approve the workYou see the written scope before anything is cut or welded

What's included

What commercial roofing covers

A commercial roof is an engagement, not a single job: multi-building work, phased schedules, equipment curbs and tenant coordination — and the roofing is planned around the business, not the other way round.

01

TPO membrane systems

Multi-building scoping: every building on the property surveyed, scoped and scheduled as one programme, not as separate jobs.

02

EPDM rubber systems

Phased work: the roof replaced section by section, so the business stays open and no more roof is open than the crew can close in a day.

03

Modified bitumen systems

Equipment curbs and rooftop units: flashing and curbs detailed around the equipment the building actually has, with the HVAC contractor coordinated, not worked around.

04

Commercial metal roofing

Tenant coordination: the schedule, the noise and the access agreed with the tenants and the property manager before the job starts.

05

Drains, scuppers and parapets

A single point of contact for the programme, with a written schedule, a written scope per building, and a handover per section.

06

Permit and final inspection

A walk-through and a handover per section: the seams inspected, the drains tested, and the roof left draining before the next section starts.

Service overview

What commercial roofing in Dallas actually involves

A commercial roof is an engagement: multi-building, phased, and planned around the business.

A commercial roof is different from a residential roof in kind, not just in size. The building stays open while the roof is replaced. The tenants stay in place. The rooftop equipment stays in service. So the work is planned as an engagement: every building on the property scoped as one programme, the roof replaced section by section so no more is open than the crew can close in a day, the equipment curbs detailed with the HVAC contractor, and the schedule agreed with the tenants and the property manager before the job starts. The membrane itself — TPO, EPDM or modified bitumen — is chosen for the building, and the system is explained on the flat roofing page. This page is about the engagement: how the work is scoped, phased and coordinated so the business underneath keeps running. Read the TPO-vs-EPDM guide on our blog.

Drainage decides the roofMulti-building programmes
Seams are the weak pointPhased, section by section
Work around the businessBusiness stays open during work
White TPO flat roof on a Dallas commercial building
How we workWe verify the cause, compare realistic options, and confirm the work before we leave.

The service timeline

What to expect on a commercial job

A commercial roofing engagement is a programme, and the sequence follows the programme: survey, scope, phase, coordinate, then hand over section by section.

01

Inspection

Every building on the property is surveyed and scoped as one programme, with a written scope per building and a single point of contact for the whole job.

Stage 1
02

Scope

The roof is replaced section by section, so the business stays open and no more roof is open than the crew can close in a day.

Stage 2
03

Preparation

Equipment curbs and rooftop units are detailed with the HVAC contractor, and the schedule, the noise and the access are agreed with the tenants and the property manager.

Stage 3
04

Install or repair

Each section is handed over before the next begins, so the business underneath is never left with an open roof overnight.

Stage 4
05

Check and handover

The handover is per section: the seams inspected, the drains tested, and the roof left draining before the next section starts.

Stage 5

Tools & methods

Tools and methods we use on your building

Commercial roofing is planned as a programme, and the tools are programme tools: scoping, phasing and coordination.

01

Hot-air seam welder

Multi-building survey: every building on the property surveyed, scoped and scheduled as one programme, with a written scope per building.

02

Seam roller and probe

Phasing plan: the roof divided into sections that can each be closed in a day, so the business stays open and no section is left exposed overnight.

03

Moisture survey tools

Equipment-curb detailing: flashing and curbs built around the rooftop units the building actually has, coordinated with the HVAC contractor.

04

Drain and level checks

Tenant coordination: the schedule, the noise and the access agreed with the tenants and the property manager before the job starts.

05

Fall protection and edge safety

Single point of contact: one person for the programme, with a written schedule and a handover per section.

06

Penetration and curb checks

Section handover: the seams inspected, the drains tested, and the roof left draining before the next section starts.

Use cases

When Dallas businesses call us

These examples show how commercial work is sequenced around the building underneath.

Flat commercial roof with TPO membrane in Dallas
TPO replacement on a Dallas warehouseA warehouse roof with an ageing membrane, seam failures and ponding at the drains. The work was sequenced in sections so the warehouse stayed open, the drainage was corrected with tapered insulation, and a new heat-welded TPO system went on with new flashing at every curb.

Leak over a retail unit in Uptown

A leak over a shop floor that appeared after every heavy rain. The cause was flashing at a rooftop unit curb that had never been sealed properly. New flashing, the curb re-sealed, and the membrane around it patched — the shop stayed open throughout.

Modified bitumen repair in Deep Ellum

Seam failures on an older modified bitumen roof over a converted commercial space, with ponding in one corner. The failed seams were cut out and re-laid, the low corner was built up, and the drains were cleared and checked for flow.

Problems we solve

Problems we solve for Dallas commercial roofs

A commercial roof fails the same way a flat roof fails — and the engagement fails when the work is not phased or coordinated. These are the problems we see most on commercial roofs in Dallas.

ISSUE

Ponding water that will not drain

A roof replaced all at once, with the business closed or the tenants disrupted — the work was not phased, and the engagement failed before the membrane did.

SYMPTOM

Seams opening on the membrane

Equipment curbs that leak because the flashing was built around the equipment as found, not detailed with the HVAC contractor.

SIGN

Leaks at rooftop equipment

Ponding on a large field, where the falls were never cut across a multi-building roof — the seams take the strain across the whole programme.

ALERT

Hail damage across the field

A leak traced to the wrong building, because the programme was never surveyed as one roof and the water travelled between sections.

Cost factors

What shapes the cost of a commercial roof in Dallas

A commercial roof is priced as a programme: the buildings, the phasing, the equipment and the coordination — and the membrane on top of it.

Phase 01

Roof size and access

The programme: every building surveyed and scoped as one job, with a written scope per building and a single point of contact.

Phase 02

System choice

The phasing: the roof divided into sections that can each be closed in a day, so the business stays open and the work is sequenced, not rushed.

Phase 03

Drainage and insulation

The membrane and the details: TPO, EPDM or modified bitumen, chosen for the building, with equipment curbs and tenant coordination planned in.

Customer reviews

What Dallas Business Owners Say

5.0★★★★★41 Google reviews
★★★★★
“the crew arrived on time, brought the team they promised, finished the roof replacement within the quoted timeline, and cleaned up the jobsite better than expected.”
DC
daniela colonGoogle review · 3 weeks ago

Questions before we arrive

Commercial roofing questions Dallas owners ask

Commercial Roofing
Call (469) 960-7533
How much does a commercial roof cost in Dallas?

A commercial roof is priced as a programme, not as a single job: the number of buildings, the phasing, the equipment curbs and the tenant coordination all shape the scope before the membrane is chosen. No figure is given here, because no two programmes are alike — the estimate follows a survey of every building on the property, with a written scope per building.

Does a commercial roof replacement need a permit in Dallas?

Yes. Dallas requires a permit before any new roof covering is applied, under City Code Chapter 52, section 301.4.6.3. The application lists where debris will go, and a final inspection follows once the work is complete and proof of disposal at a city landfill or transfer station is submitted.

What is the best commercial flat roof system for Dallas?

TPO is the most common commercial flat-roof system in Dallas: a white heat-welded membrane that reflects Texas sun. EPDM rubber and modified bitumen suit different buildings and budgets. The right system depends on the building, the foot traffic, the equipment on the roof, and how the drainage runs.

Can you repair a commercial roof without closing the building?

Yes, in most cases. The work is sequenced in sections so the building stays dry and open throughout, and disruptive work is planned with the owner or manager. If a section has to come off, it is dried in before the crew leaves for the day.

Ready when you are

Get your commercial roofing Dallas TX quote

An inspection, photos, and an itemised written quote for the work as scoped. Call (469) 960-7533 and tell us about the building.

Commercial Roofing

Talk with the local team

Request Commercial Roofing

Call us at (469) 960-7533 or send a message and we will get back to you. We are open 24 hours, every day. Tell us about the building and what the roof is doing, and we will give you a straight answer on what it needs.

3919 Cedar Springs Rd, Dallas, TX 75219Main office · technicians serve the full area

Thanks — your request is in. We will contact you shortly.

Call now