Soffit and fascia repair in Dallas

Rotted boards cut out, new timber fitted, gutters re-hung

Soffit and Fascia Repair Dallas TX | Fonseca Brothers Roofing

Fascia is the board at the edge of the roof that the gutters hang from, and soffit is the underside of the eave that closes the gap between the wall and the roof. Both rot when they stay wet — from a gutter that overflows, a roof edge that leaks, or a soffit vent that has been blocked for years. We cut out the rotted board and replace it with new timber, primed and painted, with the gutters re-hung to the new fascia and the soffit vents opened so the air can move.

Open 24 hours, every dayItemised written quotePhotos at every stage
Call firstTell us what the eaves are doing — rotting, sagging, pulling away — and where the water goes
Safety before speedWe check the eaves and the gutters from the ladder before any work is agreed
Diagnose the causeWe find how much board is rotted, and what kept it wet
Approve the workYou see the written scope before anything is cut out

What's included

What soffit and fascia repair includes

A soffit and fascia repair in Dallas is a carpentry job and a roofing job together: the rot cut out, the new timber fitted, the gutters re-hung, and the soffit vents opened. The scope is written down before the work starts.

01

Rot cut out, not painted over

The rotted board is cut out and replaced with new timber, primed and painted. A fascia that is painted over without cutting out the rot will rot again.

02

New timber, primed and painted

The replacement board is new timber, primed and painted, so the repair lasts and the paint holds. The joints are sealed where the detail calls for it.

03

Gutters re-hung to the new fascia

Gutters hang from the fascia, and when the fascia is replaced the gutters are re-hung to the new board. A gutter hung to a bad board will pull away again.

04

Soffit vents opened

Soffit vents that are painted shut or blocked are opened and cleared, and the baffles are checked, so the air can move through the attic.

05

Cause fixed, not just the board

The gutter or the roof edge that kept the fascia wet is fixed as part of the job, so the new board does not rot the same way.

06

Documented throughout

Photos of the rot, the new timber, and the finished eave, so you can see what the repair was and what it is now.

Service overview

What soffit and fascia repair in Dallas actually involves

Soffit and fascia repair in Dallas is the replacement of rotted timber at the eaves of a roof: the fascia board that the gutters hang from, and the soffit that closes the underside of the eave. The repair is to cut out the rot and fit new timber, primed and painted, and to fix the gutter or the roof edge that kept it wet — because a fascia that is painted over without cutting out the rot will rot again.

Fascia is the board at the edge of the roof that the gutters hang from, and soffit is the underside of the eave that closes the gap between the wall and the roof. Both are timber in most Dallas homes, and both rot when they stay wet — from a gutter that overflows, a roof edge that leaks, or a soffit vent that has been blocked for years. The repair is to cut out the rotted board and replace it with new timber, primed and painted, with the gutters re-hung to the new fascia and the soffit vents opened so the air can move. A fascia repair that is painted over without cutting out the rot is a repair that will be back.

Rot is cut out, not painted overFascia rots when it stays wet — from a gutter that overflows, a roof edge that leaks, or a drip edge that is missing. The repair is to cut out the rotted board and replace it with new timber, and to fix the gutter or the roof edge that kept it wet.
Fascia first, gutters secondGutters hang from the fascia, and a soft or rotted fascia cannot hold them. The fascia is repaired first, the gutters are re-hung to the new fascia, and the soffit vents are opened so the air can move.
Soffit is the attic's intakeSoffit is the underside of the eave, and it carries the intake vents that let air into the attic. When the soffit vents are painted shut, the attic starves for intake, and the roof bakes from below.
Crew replacing rotted fascia on a Dallas home
How we workWe verify the cause, compare realistic options, and confirm the repair before we leave.

The service timeline

What to expect during your soffit and fascia repair

The order is the same on every soffit and fascia job, whatever the eave.

01

Inspection

We look at the eaves from the ground and from the ladder, checking the fascia, the soffit, the gutters and the roof edge. You get photos of what we find and a straight answer on how much board is rotted.

Stage 1
02

Scope

The written scope names the board to replace, the gutters to re-hang, and the soffit vents to open, so the job is agreed before anything is cut out.

Stage 2
03

Cut out and replace

The rotted board is cut out and replaced with new timber, primed and painted, and the joints are sealed. The repair is photographed before the paint goes on.

Stage 3
04

Re-hang and open

The gutters are re-hung to the new fascia, the soffit vents are opened and the baffles are checked, so the air can move through the attic.

Stage 4
05

Cleanup and walkthrough

Debris collected, the ground swept, and a walk of the eaves with you. You see the photos of the repair before we leave.

Stage 5

Tools & methods

Tools and methods we use on your soffit and fascia

Fascia tools are for cutting and fitting timber — the saw, the primer and the paint, in that order.

01

Circular saw and pry bar

Cuts out the rotted board and lifts it without damaging the good timber around it, so the repair is clean and the new board fits.

02

New timber and primer

Replaces the rotted board with new timber, primed and painted, so the repair lasts and the paint holds.

03

Moisture meter

Finds the wet timber the leak has caused, so the repair covers the rot, not just the board that shows it.

04

Ladder and stabiliser

Gets the crew to the eave safely, with the ladder held off the gutter so the run is not bent by the climb.

05

Sealant and paint

Seals the joints where the detail calls for it, and finishes the new timber so the repair looks like it was always there.

06

Soffit vent covers

Fits vent covers that keep insects out of the attic while letting the air in, so the intake stays open and the attic stays dry.

Use cases

When Dallas homeowners call us for fascia and soffit

These examples show how a fascia and soffit repair is scoped to the rot — and the gutter that caused it.

New fascia and soffit on a Dallas home
Fascia and soffit renewed in LakewoodA home in Lakewood where the fascia had rotted behind a gutter that had been overflowing for years, and the soffit had sagged. The rotted boards were cut out and replaced with new timber, primed and painted, the gutters were re-hung to the new fascia, and the soffit vents were opened so the air can move.

Fascia rot in Oak Cliff

A 1920s bungalow where the fascia had rotted at the corners, and the gutters were pulling away from the house. The rotted sections were replaced, the gutters were re-hung to the new fascia, and the corners were sealed.

Soffit vents in North Dallas

A two-story home where the soffit vents had been painted shut years ago, starving the attic of intake. The vents were opened and cleared, the baffles were checked, and the air began to move again.

Problems we solve

Problems soffit and fascia repair solves for Dallas homes

Most soffit and fascia calls are one of these four. Each one starts with the same question: how much board is rotted?

ISSUE

Fascia rotting behind the gutter

We cut out the rotted board and replace it with new timber, primed and painted, and fix the gutter that kept it wet.

SIGN

Gutters pulling away from the house

A gutter hung to a rotted fascia will pull away. We repair the fascia first, then re-hang the gutters to the new board.

SYMPTOM

Soffit sagging or stained

A sagging soffit is a sign of rot or water behind it. We open the soffit, find the wet timber, and replace what is rotted.

ALERT

Soffit vents painted shut

Vents that are painted shut starve the attic of intake. We open the vents and check the baffles, so the air can move.

Cost factors

What shapes the cost of soffit and fascia repair in Dallas

HOW MUCH BOARD IS ROTTED, AND WHAT HUNG FROM IT

Phase 01

Length of the rot

A short section of fascia is a small job. A full run of fascia and soffit, rotted along its length, is a bigger one.

Phase 02

Gutters to re-hang

Gutters hang from the fascia, and when the fascia is replaced the gutters are re-hung to the new board. The re-hang is part of the scope.

Phase 03

Soffit vents

If the soffit vents are painted shut or blocked, opening them is part of the job. An attic with no intake bakes, and the repair should not leave it that way.

Customer reviews

What Dallas customers say

5.0★★★★★41 Google reviews
★★★★★
“I hired a roofing and exterior crew to replace the fascia, corner trim, gutters, and the front siding on my home. The work turned out excellent, and the whole project was handled with real care.”
JH
Jesus HoodGoogle review · 3 weeks ago

Questions before we arrive

Soffit and fascia questions Dallas homeowners ask

Soffit and Fascia Repair
Call (469) 960-7533
Why does fascia rot in Dallas?

Fascia rots when it stays wet — from a gutter that overflows, a roof edge that leaks, or a drip edge that is missing. The repair is to cut out the rotted board and replace it with new timber, primed and painted, and to fix the gutter or the roof edge that kept it wet. A fascia that is painted over without cutting out the rot will rot again.

How much does soffit and fascia repair cost in Dallas?

It depends on how much board is rotted, whether the gutters need re-hanging, and whether the soffit needs work too. A short section of fascia is a small job; a full run of fascia and soffit is a bigger one. We inspect first and give you an itemised written quote for the repair as scoped.

Can you repair fascia and gutters together?

Yes. Gutters hang from the fascia, and a soft or rotted fascia cannot hold them. The fascia is repaired first, the gutters are re-hung to the new fascia, and the soffit vents are opened so the air can move. A gutter hung to a bad board will pull away again.

What does the soffit do?

Soffit is the underside of the eave, and it carries the intake vents that let air into the attic. When the soffit vents are painted shut or blocked, the attic starves for intake, and the roof bakes. The repair opens the vents and checks the baffles, so the air can move.

Ready when you are

Get your soffit and fascia repair Dallas TX quote

An inspection, photos, and an itemised written quote for the soffit and fascia repair as scoped. Call (469) 960-7533 and tell us what your eaves are doing.

Soffit and Fascia Repair

Talk with the local team

Request Soffit and Fascia Repair

Call us at (469) 960-7533 or send a message and we will get back to you. We are open 24 hours, every day. Tell us what the eaves are doing — rotting, sagging, pulling away — and we will give you a straight answer on what they need.

3919 Cedar Springs Rd, Dallas, TX 75219Main office · technicians serve the full area

Thanks — your request is in. We will contact you shortly.

Call now